팔루다리움 1호 전경수초씨앗 심기(드디어찾음)

I pulled out a few begonias this week for members of the store’s ukulele. I’m very satisfied because the roots are much healthier than the shovel water rack.After an hour or two, the small flakes on the water sink down. Now you just have to wait for the seed to germinate and sprout. Isn’t it easy?Very simply, let’s summarize how to plant water plants in the paludarium with a few pictures.the collected water plants and the water plants to be planted2. cover soilDrain the water. While you’re at it, it’s better to fill it with new water and get it back through the process of removing it again. I already did a partial recovery last month. And if you can afford it, remove moss and stains from the glass wall and wipe it off.4. Fill it with water.Skinny cherry red. I think Marley’s stem looked better considering the atmosphere of Paludarium 1. However.I’m lazy to say that I didn’t do the side finish on purposeIf the foreground water plants sprout, it will raise the water levelNext to the paludarium, rather than pouring the seeds directly onto the sows planted with it, prevents the loss of seeds planted by pouring water on the back as much as possible. The water level must be lower than the height of the side drainage layer so that the growth of plants in the ground is not hindered.H. sipitangensis Hoya Cherry RedIf the water is stagnant, the seeds float, so remove the water as much as possible and cover it with soil.#Hoya #Malley #CherryRedAt this time, if you cover it too lightly, the seeds may be lost in water. If you cover it too deeply, the seed germination rate decreases or shoots, which takes a long time.Replaced with cherry red stems instead of mali#Making Paludarium #WaterplantSeeds1. Drain the water3. After sowing the seeds, cover the stomach slightly with soy sauce again.I got information that H. Numularides is struggling with humid conditions